Instant 1 MW Power Boost for Offshore Gas Re-Injection Well
Project Profile: A strategic upgrade on a Rolls Royce RB211 marine gas turbine resulted in a substantial......
Inlet Cooling & Wet Compression Boosts Power Output by 20 MW
Gas Turbine Inlet Air Cooling
In 2000, MeeFog systems were installed on two Siemans V64.3 gas turbines. These systems offer both inlet cooling and wet compression. Wet compression consists of spraying water into the gas turbine compressor. The water evaporates inside the compressor giving an inter-cooling effect that reduces the work of compression, which causes an increase in power output. Each system provides a 10 MW power boost resulting in a 20 MW boost for the plant. This customer continues to get maximum output with MeeFog whenever additional load is required.
Project Conditions:
- Model: Siemans V64.3
- Hot day conditions: 101.3° F with 83.5° wet bulb
- Elevation: Sea Level
- Mee’s scope of work: design, build, supervise installation
- Max power boost per GT: 10 MW
Fog System Design:
- Fogging Stages: 9
- Operating Pressure: 2,000 psi
- Fog Droplet Size: 14 microns
- MeeFog Nozzle Count: 648
- Nozzle Flow Rate: 0.17 lpm per nozzle
- Max. Water Flow: 110.2 lpm
- Max. Power Requirement: 45 HP
Learn More
Want to learn more about successful Meefog systems installation projects and case studies?
Other Related Blog Articles
Gas Turbine Inlet Air Cooling
Gas Turbine Inlet Air Cooling
Vietnam’s Largest Power Plant Gains 60 MWs with MeeFog Cooling System
Project Profile: Learn about the custom-engineered solution that enhances gas turbine performance under extreme cond...
Gas Turbine Inlet Air Cooling
20 MW of Power Recovery at Load-Following Power Plant
Case Study: Faced with the challenge of maintaining optimal power output as equipment aged and temperatures rose,......